Indy Joneds
Elite Cafe Member
self centering ? simple rotating ? or non rotating ? or tilting ? or just heavy?
jaw opening width ? 4" a good start ?
I have seen some bits here and there that show engravers finding what apears to be the centre of the rotating device which there vice sits on i.. im guessing that this is so that you turn the vice to aid your cut and it follow in a circular motion rather than an oval ( if the vice was offset from centre ) i am guessing at all this but basically .. if this is needed or a self centreing vice is a big life safer then this would be great to know . I would rather buy ONE CORRECT vice than waste money . thanks
jaw opening width ? 4" a good start ?
I have seen some bits here and there that show engravers finding what apears to be the centre of the rotating device which there vice sits on i.. im guessing that this is so that you turn the vice to aid your cut and it follow in a circular motion rather than an oval ( if the vice was offset from centre ) i am guessing at all this but basically .. if this is needed or a self centreing vice is a big life safer then this would be great to know . I would rather buy ONE CORRECT vice than waste money . thanks