RT Bit and Spur
Elite Cafe Member
- Joined
- May 17, 2007
- Messages
- 279
I am a bit and spur maker and make my own engraving vices. I was going to make a vice to use under my microscope. I had a couple of questions for people that cut with a scope.
1) Does the vice need to have a ball sense it should be straight up under a scope?
2) Why can't the turn table just be a plate on a shaft with bearings attached to a stand because the turn table doesn't move The vice does.
Rod
1) Does the vice need to have a ball sense it should be straight up under a scope?
2) Why can't the turn table just be a plate on a shaft with bearings attached to a stand because the turn table doesn't move The vice does.
Rod