Arnaud Van Tilburgh
~ Elite 1000 Member ~
I just finished the shading of this Titanium ring. The sides have a running leaf border I showed earlier.
The design was drawn using Sam's transfer wax directly on the ring under the scope. I know there are perhaps some areas where I could have ad a extra leaf, anyhow, no one can see the engraving in one, so perhaps it is allowed if the design is not totally in balance.
The dimensions for this lady wedding ring is 10mm wide, diameter 17mm high of the profile 1,7 mm
comments as always are welcome, arnaud
The design was drawn using Sam's transfer wax directly on the ring under the scope. I know there are perhaps some areas where I could have ad a extra leaf, anyhow, no one can see the engraving in one, so perhaps it is allowed if the design is not totally in balance.
The dimensions for this lady wedding ring is 10mm wide, diameter 17mm high of the profile 1,7 mm
comments as always are welcome, arnaud