Question: Rossi 44 magnum

[Chujybear]

Just wondering if anybody has any experience cutting one of these?
Hard, easy?
Am I giving enough information to answer?
It's a cute little gun. Looks like a rifle for an infant. (not a reccomendations)
Thank you
Gwaai

 

[Chujybear]

My brother is going to carve the stock.
Looking at the rest of it.

 

[Chujybear]

No?
Figure someone must have tried one of these. Seem like a decent enough canvas...

 

[Roger Bleile]

It may be a "decent enough canvas" but very few Rossis get engraved because, once engraved, they won't sell for the price of the gun and engraving combined. This is true of many guns and has been discussed here before. American engravers make their living on well known American made guns such as Colt, S&W, Winchester, Parker, and so forth.

RB

 

[Chujybear]

I see.
So likely I won't find anybody who has bothered on here then?
It's a bit different market I deal with, this is just a carving job. But wouldn't tackle it if there were known issues.
Thanks Mr Bleile, at least for the nod

I'm not sure where it comes from. I know my own gun. And that's about the extent of my knowledge.

 

[Beathard]

I've done one. It was pretty easy to engrave. It was for a cowboy action guy to shoot for fun. He didn't care about the resale.

 

[Chujybear]

Thank you Beathard.