Eric Olson
Elite Cafe Member
This is a Spyderco "Kiwi", one of their smaller models. It has an interesting shape an also nice flat sides.
I drew the design enlarged on paper, then traced, reduced and printed it with "Inkscape" freeware.
I used wire for the narrow parts. Then rolled a Canadian Maple leaf coin into a sheet, and cut pieces to fit the wider areas.
Since the Kiwi has no pocket clip, this will also be my first attempt at mirroring the design on the other side.
I grumbled a lot, but I think the effect is worth it.
I drew the design enlarged on paper, then traced, reduced and printed it with "Inkscape" freeware.
I used wire for the narrow parts. Then rolled a Canadian Maple leaf coin into a sheet, and cut pieces to fit the wider areas.
Since the Kiwi has no pocket clip, this will also be my first attempt at mirroring the design on the other side.
I grumbled a lot, but I think the effect is worth it.