bergermeister
Member
- Joined
- Sep 25, 2014
- Messages
- 7
I have done some hammer graving on longrifle mild steel and brass. I was curious if anyone has taken the same tools to a hard anodized aluminum receiver ? If'n so, how did it work out..:hammer:
welcome to the forum. i've only done 1 gun that was an aluminum alloy. it was cranky stuff to work with. perhaps a member with more experience could chime in here. got any fotos of your work ? if you do, send a few.
Ron,NEVER use an end mill in a drill press, or in a lathe, as that's courting disaster.
I always thought that was a stupid expression. Any gun is a tack driver IF you can hit the tack. I was at a rendezvous in Natchez once and they had a bunch of tacks in a board at 25 yards. Nobody could hit them, until Matt Avance (TVM) took a lucky shot. We all agreed thereafter, he could advertise that his guns were tack drivers.It's a tack driver
Any gun is a tack driver IF you can hit the tack.