LVCIAN
Member
My new tools arrived and I'm well and truely excited.
Brand new Graver MachAT and 901 QC AT hand piece.
I've only really hand pushed before so the AT is a really exciting feature.
For those of you that use it, do you recommend an initial set up for the hand piece?
(Currently set up with a #6 pad and the .. palm cap)
Also, this hand piece, even at its shortest, is much longer than I'm used to. Brand new gravers are about an inch longer than my thumb. Can the pre-ground gravers be cut off on the back end without effecting the QC Holders ability to grasp the tool?
Brand new Graver MachAT and 901 QC AT hand piece.
I've only really hand pushed before so the AT is a really exciting feature.
For those of you that use it, do you recommend an initial set up for the hand piece?
(Currently set up with a #6 pad and the .. palm cap)
Also, this hand piece, even at its shortest, is much longer than I'm used to. Brand new gravers are about an inch longer than my thumb. Can the pre-ground gravers be cut off on the back end without effecting the QC Holders ability to grasp the tool?