Patrice Lemee
Member
As I said in another thread, my Meister doesn't run at the higher speeds like it should.
At the lowest speed, the tensionning pulley is like this and it works great.
But at the highest speed it doesn't apply enough tension and the belt slips.
If I go by the chart in the lever cover, it starts slipping at around 1050-1100.
My Google Fu is weak. I did a search over here but can't find anything.
Any ideas? Thanks.
At the lowest speed, the tensionning pulley is like this and it works great.
But at the highest speed it doesn't apply enough tension and the belt slips.
If I go by the chart in the lever cover, it starts slipping at around 1050-1100.
My Google Fu is weak. I did a search over here but can't find anything.
Any ideas? Thanks.