conan
Member
I have lots of gravers from GRS. All of them are for the gravermeister that Ray Phillips set me up with.
I have never cut a heel on any of them because the sales people at GRS told me they were ready out of the package. I think my engraving is barely passable after a year.
How do I shape the gravers with a knife edge, round edge, square edge or the ones with lines. Are they truly ready out of the package.
Unfortunately, Sam A and Rex P of FEGA.,know of no one in Alabama close to Birmingham to teach.
I am new so, as they say the only dumb question is one unasked or I don't mind research, just point me. I have all the books, they don't address the gravermeister gravers from GRS.
Conan (DR Lowery MD)
ADDENDUM!!
I have the gravermeister. Bought it from Ray Phillips. Since that time I have added the grs power hone with all the wheels and the dual angle fixture. I have the grs standard block and all the attachments. I also have the grs silent aire with an Ultra 850 handpiece and all its attachments. A 915 handpiece with the quick change stuff, the emax.
I have been using the QC gravers but they don't have a heel, also do you turn them up or turn the long side down. I NEED HELP.
I have all the books in print and all the scroll sets by grs and scm.
ANY help is appreciated. I don't see how the QC gravers are ready out of the pack.
Conan
I have never cut a heel on any of them because the sales people at GRS told me they were ready out of the package. I think my engraving is barely passable after a year.
How do I shape the gravers with a knife edge, round edge, square edge or the ones with lines. Are they truly ready out of the package.
Unfortunately, Sam A and Rex P of FEGA.,know of no one in Alabama close to Birmingham to teach.
I am new so, as they say the only dumb question is one unasked or I don't mind research, just point me. I have all the books, they don't address the gravermeister gravers from GRS.
Conan (DR Lowery MD)
ADDENDUM!!
I have the gravermeister. Bought it from Ray Phillips. Since that time I have added the grs power hone with all the wheels and the dual angle fixture. I have the grs standard block and all the attachments. I also have the grs silent aire with an Ultra 850 handpiece and all its attachments. A 915 handpiece with the quick change stuff, the emax.
I have been using the QC gravers but they don't have a heel, also do you turn them up or turn the long side down. I NEED HELP.
I have all the books in print and all the scroll sets by grs and scm.
ANY help is appreciated. I don't see how the QC gravers are ready out of the pack.
Conan
Last edited: