rmgreen
Elite Cafe Member
I have just made several smoke pulls of factory engraving. I would like to use these to make practice plates and to learn to use CS2 Illustrator. What I would like to accomplish with CS2 is to: 1 - select one of these pulls (several are on the same sheet of paper scanned into my PC). 2-Copy and save as an individual file. 3-Make the pull into a negative(positive?)so that the actual cuts are black and not white. 4-Increase/decease size. 5-Save as changed.
Perhaps I am asking too much and/or such a requests exceeds the forums purpose. Thanks for any help or were I can go to find help. Roger
Perhaps I am asking too much and/or such a requests exceeds the forums purpose. Thanks for any help or were I can go to find help. Roger