JenBrockman
Member
So....I'm just learning. I was fiddling around with this trying to figure out the beveled cuts on leaves. More than anything I have such a tough time with "rolling" the graver to get a beveled cut. I just CAN NOT figure that out! Practice practice practice....I know. I will get it eventually. My question is.....are there rules to bevel cutting? You should cut towards the inside right? Any other rules.
This is a practice piece i was messing around with. I think the design belongs to Sam, it was a practice design I printed from the cafe.
I can point out lots of ooops now that I look at the pic....i didn't back cut, see lots of "flat" spots, lines crooked, a few I deviated from the design and mucked it up, etc.....it all comes with learning. And like I said....just fiddling so this is not something I would consider to be a nice finished piece.
Suggestions??? Advice???
This is a practice piece i was messing around with. I think the design belongs to Sam, it was a practice design I printed from the cafe.
I can point out lots of ooops now that I look at the pic....i didn't back cut, see lots of "flat" spots, lines crooked, a few I deviated from the design and mucked it up, etc.....it all comes with learning. And like I said....just fiddling so this is not something I would consider to be a nice finished piece.
Suggestions??? Advice???