Dupont24
Member
I've been having excellent luck with my 120 graver by sharpening according Sam's Expert Guide to Graver Sharpening, but starting today my luck ran out. I've had to sharpen three times after about 20-30 minutes of cutting because the graver keeps chipping. What are some common pitfalls for newbies like me? I've used both 45 and 50 degree faces with 15 degree heel, both chipped. I used 1200 grit diamond finish and ceramic, both chipped. Could I be pushing to hard instead of letting the hand piece do the cutting? I'm using a Monarch, I think, so I find myself pushing pretty hard to compensate for the small hand piece. Would the 901 be better or worse? I'm just brainstorming, but your tips are appreciated.