beegee
Elite Cafe Member
I went to engraving class several years ago and didn't have time to get my stuff set up. Now, I'm ready to start setting up my bench. I learned basic hammer engraving and really want to use my machines. I have an older Gravermeister that I bought cheap and then I got a good deal on a GraverMax. I plan to primarily do some pocket knives and banjo parts to start, maybe do some guns. I just bought a new 80 gallon upright compressor located outside under the shelter that I'm plumbing into my shop to run air tools. I will have a drop for my GraverMax with oil/water trap/ regulator, etc. Is there any practical advice for getting this thing going. I have the instruction book somewhere, but don't know where. I guess GRS could supply new instructions?
