mitch
~ Elite 1000 Member ~
- Joined
- Jul 23, 2007
- Messages
- 2,636
i needed to do just a bit of restoration work on this old H&H top lever and didn't want to spend an hour fixturing the darn thing for 15 minutes of engraving. one my Cylinder Blocks & a glob of GRS Thermo-loc had me plowing away it in less than 10 minutes, at any weird angle i might need. while this job only gets a little light border work, the part is held securely enough for deep-relief chiseling. (these blocks are available thru www.EngraversStudio.com or www.GRSTools.com)