Jack Davenport
Member
This went on another gents knife with gold sheild and pins.
Attachments
-
ivorygold.jpg
another crossed ribbon
- Thread starter Jack Davenport
- Start date
Brad Hartliep
Member
Nice and clean and simple...I like it!
Jack Davenport
Member
gents knife
Thanks all: Ron the name is etched through a stencil that I make, using low dc voltage for the etch then low ac voltage to create the iron oxide that darkens the letters. this crossed ribbon is the only thing that I can draw easily at this time so between the pressure of upcoming shows and the magnetic draw that my engraving bench creates in my shop this is all that I dare at this time. Thanks again for the critique. Jack D.
Thanks all: Ron the name is etched through a stencil that I make, using low dc voltage for the etch then low ac voltage to create the iron oxide that darkens the letters. this crossed ribbon is the only thing that I can draw easily at this time so between the pressure of upcoming shows and the magnetic draw that my engraving bench creates in my shop this is all that I dare at this time. Thanks again for the critique. Jack D.
ddushane
~ Elite 1000 Member ~
Beautiful work Jack. I like the pin too! Simple but nice. Dwayne
Sponsors
