mark c
Member
hello im new on here . ive been working on my engraving for about 6 months. Im not quite sure that im understanding all of the gravers and there use, im useing mostly the square , 120 and flat at this point. Im getting mixed results and some times wonder what im doing. Its a strugle to figure out what is the best tool for the job, I have over 35 years at the bench and have taken the bench coarse at GRS . its just the basic stuff , sharping and such. ill do my best to read the posts ad try to under stand what i see. The posts that i have seen have given me the encouragement to keep going . thanks mark c