some bright cut engraving

didyoung

~ Elite 1000 Member ~
Joined
May 22, 2008
Messages
2,253
Location
Laurel, Montana, United States
so far i have chipped 2 graver corners while engraving this marlin.
i am happy with the engraving......could be lots better, but lots of practice will cure that.
shawn
 

eastslope

~ Elite 1000 Member ~
Joined
Jan 16, 2008
Messages
1,008
Location
Conrad, MT
That is pretty darn cool Shawn. Those are some BIG scrolls and very long cuts. I have a 44 Marlin in the stainless that I have been eyeballing for a couple of years now. The only reason I haven't done anything is that it spends so much time wet and muddy hanging off the side of my saddle horse. My camp gun. Keep us posted.
 
Last edited:

Latest posts

Sponsors

Top