Jim Sackett
Elite Cafe Member
I cut this on a 1 1/4 x 2 inch piece of Cronite's 16 gage cold stamped engravers steel. It cuts and holds the graver very nicely.
Would appreciate any feed back & ideas on layout and technique. I tryed to get that raised look in the center of the letter by slanting the deepest cuts on the outside of letter. Using a flat graver, when I do this again I will make the lettering smaller.
I used a 90 square on the scroll work. All comments and suggestions invited.
Jim Sackett
Would appreciate any feed back & ideas on layout and technique. I tryed to get that raised look in the center of the letter by slanting the deepest cuts on the outside of letter. Using a flat graver, when I do this again I will make the lettering smaller.
I used a 90 square on the scroll work. All comments and suggestions invited.
Jim Sackett
Last edited:
