CJ Tate
Elite Cafe Member
Beautiful bracelet design and an exciting start.
Arnaud, I wanted to ask about your bench configuration. I recently purchased the grs microscope w/arm and keep staring at my setup trying to figure out where I am going to install it. I did not occur to me to put it at my jewelry bench.
Do you have 2 benches? one for regular jewelry work and one for engraving? I see you have the interchangable mount for bench pin/vice shelf. My best natural light is at the bench, so using one bench for both would be good. (I did get light ring for scope.) I guess it would mean moving the vice and shelf quite a bit - but I could use it for jewelry occasionally too. I don't do a lot of faceted stone setting but I do some.
Thanks in advance for your thoughts and opinion. - Candy
Arnaud, I wanted to ask about your bench configuration. I recently purchased the grs microscope w/arm and keep staring at my setup trying to figure out where I am going to install it. I did not occur to me to put it at my jewelry bench.
Do you have 2 benches? one for regular jewelry work and one for engraving? I see you have the interchangable mount for bench pin/vice shelf. My best natural light is at the bench, so using one bench for both would be good. (I did get light ring for scope.) I guess it would mean moving the vice and shelf quite a bit - but I could use it for jewelry occasionally too. I don't do a lot of faceted stone setting but I do some.
Thanks in advance for your thoughts and opinion. - Candy