View Poll Results: What is your main tool for cutting a channel for gold inlay?

129. You may not vote on this poll
  • Onglette

    19 14.73%
  • Round

    7 5.43%
  • Flat

    57 44.19%
  • 90

    18 13.95%
  • 105

    7 5.43%
  • 120

    9 6.98%
  • Other

    12 9.30%
Results 1 to 10 of 44

Threaded View

  1. #37
    Join Date
    Jun 2007
    5mi from the nearest Dunkin Donuts in Tennessee
    Post Thanks / Like



    The graver config is not much different than a graver tapered with a Lindsay template. Grind the bottom "V" flat and then turn it upside down just as it looks in the diagram. It doesn't matter how it is done, just as long as it is offset and tapers to a very small flat point. I don't have any specific dimensions .. wish I did .. the first time I did this I just used an old graver and ground the bottom of the "V" off as mentioned above. Ron P. showed me that actually.

    Just gotta give it a try man ...

    Catch ya later ... time is short.
    Last edited by Christopher Malouf; 03-01-2010 at 11:53 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts


Download Videos

Jumbo Pin Plates

GRS Skyscraper

Cafe page views since 18-Nov-2006.