Billzach
Elite Cafe Member
I,m getting ready to do my first pistol engraving and need to know about the hardness of Bond Arms stainless pistols...
Help on first pistol engraving
- Thread starter Billzach
- Start date
Weldon47
~ Elite 1000 Member ~
Billzach,
I have done one of the Bond derringers & had no problem at all: it cut great (for stainless).
WL
I have done one of the Bond derringers & had no problem at all: it cut great (for stainless).
WL
Powderhorn
Elite Cafe Member
Billzac;
You will find that they cut very nice for stainless, however, if yours has a trigger gard, it is not the same material as the gun. You can cut it, but t is mushy, but cuttable.
You will find that they cut very nice for stainless, however, if yours has a trigger gard, it is not the same material as the gun. You can cut it, but t is mushy, but cuttable.
your extraordinary hobos make me excited to see this gun.
handengraver
Elite Cafe Member
Great choice!
You will love working on it. For first gun there could not be a better choice. My first gun was also a Bond Texas Defender, by then I was using the old Gravermaister. Even so, it was an encouraging experience that gave me the false impression that all guns would cut like that...
Ivan
You will love working on it. For first gun there could not be a better choice. My first gun was also a Bond Texas Defender, by then I was using the old Gravermaister. Even so, it was an encouraging experience that gave me the false impression that all guns would cut like that...
Ivan
Sponsors
