nicglass1
Member
hello from Iraq everyone! well i finally was able to find some really neat little knives with what appeared to be a stainless handle. of course i dont have pictures of one to show you becuase something about the guys around here not wanting you to use a thumb drive in their computers. anyway, this dang handle is HARD AS HECK! i am just push engraving since i wasnt able to bring the gravermiester. it cuts oddly... it seems to be ok then it starts to "start and stop" almost like you popped the clutch in an old chevy. when i try to control this the graver ends up slipping and making a huge gash across it. also i am breaking tips like never before on this thing... i am going to steepen the face angle and see it that helps, but is there anything that anyone can tell me to help with the cutting? the metel is not stamped or marked anywhere on it. if i had my gravermiester then it would not be a problem cuz i can cut almost anything with it, just have to slow down, but with pushing... but hey, i only paid $1.50 for this knife from the haji shop, so i guess you get what you pay for.