First project finally finished
- Thread starter DaveH
- Start date
Weldon47
~ Elite 1000 Member ~
Dave,
For a first engraving project I think you did a remarkable job! I know how you feel - I am rarely satisfied when I get done with a piece & I am sure most of see things we would do differently the next go-round!
Keep it up and continue to look at your work with a critical eye & you will continue to improve!
My thoughts,
Weldon
For a first engraving project I think you did a remarkable job! I know how you feel - I am rarely satisfied when I get done with a piece & I am sure most of see things we would do differently the next go-round!
Keep it up and continue to look at your work with a critical eye & you will continue to improve!
My thoughts,
Weldon
very elegant looking. i should say for a first engraving project, aint nothing wrong there !
quite lovely.
quite lovely.
Arnaud Van Tilburgh
~ Elite 1000 Member ~
Looks good, certainly for a first project.
How did you do the colouring?
Arnaud
How did you do the colouring?
Arnaud
The coloring is an epoxy resin called "Colores" You mix the color you want with the appropriate type of hardener, anywhere from very thin to fill cracks to very thick (which I used here) to apply to smooth or domed surfaces. I put it in a squeeze bottle with a needle tip and squeezed it out where I wanted it. Easiest part of the whole process.
BrianPowley
~ Elite 1000 Member ~
Nice stuff...I'll bet you're glad to the first one under your belt!
Now onward!!!
Now onward!!!
Sponsors
