Michael Karlsson
Member
Is there any one who has a tip for transferring a pathern on too a ring, and get it centred and straight?
question
- Thread starter Michael Karlsson
- Start date
it's a snap if you can print it in reverse on transparent film. adjust to size in your computer program if you're that advanced. since it's transparent, centering is very easy. if you're not too advanced in technique , you can lay down a bit of beeswax on your ring.. draw your design to size with a very soft pencil. use transparent tape to lift the pencil drawing off the paper. transfer this onto the ring and center it. then burnish it down with a smooth stick. enough carbon should transfer to show your design. if it's not centered, wipe it off and try again. when the design shows well enough, you can scribe over the lines so as to not lose them.
Sponsors
