Charlie,
This is one that I made for myself. It's probably crude and bulky compared to what others use, but it's good enough for the guy using it.
I had a friend who owed me a favor turn a dozen of these heads for me. I told him they were flat tappets for a straight 8 Buick engine. I bored a hole in a square of hard maple and glued in a section of 3/8ths hickory ramrod for flexibility. As a beginner, it has served me well enough up to now.
Dave
This is one that I made for myself. It's probably crude and bulky compared to what others use, but it's good enough for the guy using it.
I had a friend who owed me a favor turn a dozen of these heads for me. I told him they were flat tappets for a straight 8 Buick engine. I bored a hole in a square of hard maple and glued in a section of 3/8ths hickory ramrod for flexibility. As a beginner, it has served me well enough up to now.
Dave