JCP
Member
I'm trying to design something for my black powder cartridge rifle octagon barrel. It will be cut just in front of reciever ring on top flat. I'm new at this and my engraving is awful but coming along as I learn to sharpen engraver and realize when it's getting dull or broken.
tell me what you think about design and the cuts, good or bad. Some times the truth hurts but it's the best help for this kind of work
It was drawn with pencil on paper and transfered using Mike Cirelli's solution.
The (WINCHESTER) was printed on tracing paper and transfered using Mike's solution.
Thanks
Jack Phillips
http://i2.photobucket.com/albums/y18/JCP11/ENGRAVING003.jpg
tell me what you think about design and the cuts, good or bad. Some times the truth hurts but it's the best help for this kind of work
It was drawn with pencil on paper and transfered using Mike Cirelli's solution.
The (WINCHESTER) was printed on tracing paper and transfered using Mike's solution.
Thanks
Jack Phillips
http://i2.photobucket.com/albums/y18/JCP11/ENGRAVING003.jpg