Fixtures

monk

Moderator
Staff member
::::Pledge Member::::
Joined
Feb 11, 2007
Messages
10,857
Location
washington, pa
chech the archives. there have been a few made by some of the members. there's also a dude that sells them. check the search bar. lotsa surprises there.
 

John B.

Lifetime Pledge Member
::::Pledge Member::::
Joined
Nov 9, 2006
Messages
3,950
Location
Los Angeles area, California.
I'm looking for information and or suggestions on fixtures for holding single action revolvers for engraving. I use a grs self centering ball vise.

Mike Dubber makes a top flight set of SAA fixtures. They are available from GRS
See the advertisement in the latest edition of the FEGA Engraver magazine.
 

tdelewis

Elite Cafe Member
Joined
Oct 10, 2010
Messages
752
Location
Volant, PA 60 miles north of Pittsburgh
You might try a small wood clamp. Drill the pads to insert a brass point that is large enough so it will not fit all the way in the barrel. It will work for the cylinder also. You might look for a plastic rod that can be shaped and glued in the drilled holes.
 
Top