My last job of 2017

Rstripnieks · Jan 2, 2018

Here is my last work on a watch case I did at end of December ,that stainless was no ordinary watch stainless but was much much harder to cut.
Happy New Year!
All Critique welcome to help me improve!

mdengraver · Jan 2, 2018

Good way to end your engraving year!

monk · Jan 2, 2018

a minor critique-- the scroll on the far right is a bit squashed. nobody but an engraver will ever notice. was this from a botched layout, or just a bad cut on the fly ? overall, very nice to my eye.

Rstripnieks · Jan 3, 2018

Yes,Monk I noticed that when I had already cut all the lines,
I suppose my transfer film sliped a bit during burnishing amd in that moment I didnt notice that one side turned out to be different a bit, well atleast client was very very happy how it turned out.

mdengraver · Jan 3, 2018

When I zoom in it still looks pretty good! The scroll doesn't look squashed to me!

monk · Jan 3, 2018

Rstripnieks said:
Yes,Monk I noticed that when I had already cut all the lines,
I suppose my transfer film sliped a bit during burnishing amd in that moment I didnt notice that one side turned out to be different a bit, well atleast client was very very happy how it turned out.

well, tiny details that would cause most of us to lose sleep over, the average client aint ever going to see it. even if one were to point it out, most do not see the way engravers do.

My last job of 2017

Rstripnieks

Member

Attachments

mdengraver

~ Elite 1000 Member ~

monk

Moderator