tayloredcreations
Member
Here are pictures of a practice buck knife I got from GRS, it is my first time engraving scroll and all I've done thus far are curves and lines on brass sheet. The design was lightly laser engraved on there at GRS so it is not my design, this is merely for practicing my engraving technique. For some reason I feel like my cuts aren't the right depth but I have nothing to really go off of, I only see people's final pictures for comparison. I also struggle with tight turns still and have a lot of little mistakes but more room for improvement I suppose. To add, I started cutting on the right and I feel that my first few initial cuts were much worse then the rest. (poor curves among many other things)
Any feedback positive or negative is greatly appreciated. Sam A, let me have it...
Any feedback positive or negative is greatly appreciated. Sam A, let me have it...