mitch
~ Elite 1000 Member ~
- Joined
- Jul 23, 2007
- Messages
- 2,636
i've been thinking about getting a 120 and was wondering a few things (that are not immediately obvious from the info on the GRS site).
what are the various angles of the finished point?
from the instruction sheet it appears the rough shaping grind is not 0, but slightly elevated. if it doesn't create a level 120 bottom surface, how often does it need touched up?
the heel is not quite a full 'parallel' heel and there is some mention of it being about 108(?), which i take to mean that it doesn't maintain a full 120. i couldn't find any mention of the angle at which the heel is raised- 15? 20?
and the face angle is spec'd as "<50", so maybe 48? 49?
any of this make sense?
what are the various angles of the finished point?
from the instruction sheet it appears the rough shaping grind is not 0, but slightly elevated. if it doesn't create a level 120 bottom surface, how often does it need touched up?
the heel is not quite a full 'parallel' heel and there is some mention of it being about 108(?), which i take to mean that it doesn't maintain a full 120. i couldn't find any mention of the angle at which the heel is raised- 15? 20?
and the face angle is spec'd as "<50", so maybe 48? 49?
any of this make sense?