Hi,
Actualy I am not sure where to begin or how to ask this question but I will try to explain it with this drawing.
When I cut with large geometry like 100 - 105 - 110 and 120 lines are darker, but when I cut with narrower geometry like 75 - 80 - 90 lines are shiny and I need to put paint in those cuts.
When I look at the this drawing, the black graver ( 105 degre ) doesn't go deeper but it cuts larger line. When I try to cut the line with red graver ( 75 degre ) and go to same deep it cuts narrower lines,
How about if I go deeper with red graver ? If I go a little bit deeper it cuts as large as black graver, but result is the same, no matter how deep I go I still have shiny cuts with red one.
Does anybody explain this to me ?
Actualy I am not sure where to begin or how to ask this question but I will try to explain it with this drawing.
When I cut with large geometry like 100 - 105 - 110 and 120 lines are darker, but when I cut with narrower geometry like 75 - 80 - 90 lines are shiny and I need to put paint in those cuts.
When I look at the this drawing, the black graver ( 105 degre ) doesn't go deeper but it cuts larger line. When I try to cut the line with red graver ( 75 degre ) and go to same deep it cuts narrower lines,
How about if I go deeper with red graver ? If I go a little bit deeper it cuts as large as black graver, but result is the same, no matter how deep I go I still have shiny cuts with red one.
Does anybody explain this to me ?