Eric Olson
Elite Cafe Member
A local gun shop sold me a slide at cost, so I cut it in half and engraved a sample for each of us to show.
1911 slides
- Thread starter Eric Olson
- Start date
Brian Marshall
~ Elite 1000 Member ~
Didja cut it in half with a 2/0 blade in a sawframe?
Nice job on the engraving.
Brian
Nice job on the engraving.
Brian
Eric Olson
Elite Cafe Member
Indeed I did use a jeweler's saw, but I think the blade(s) was #4.
Took about 1/2 hour.
Took about 1/2 hour.
dlilazteca
~ Elite 1000 Member ~
Im looking for that type of 1911 slides, where can i buy some? Square in the front.
GunEngraver.com Custom Guns Knives and More PAYMENT PLANS Available
GunEngraver.com Custom Guns Knives and More PAYMENT PLANS Available
dclevinger
Elite Cafe Member
Carlos, that is actually an aftermarket Glock slide rather than a 1911. I have yet to see a square front 1911.
Eugene Carkoski
Elite Cafe Member
looked like a s&w to me.
Sponsors
