Pendant and drawing

didyoung · Dec 20, 2016

The pendant is 16 gauge Sterling.
I think the long leaf is a bit too straight on the inside curve.
Like the saying goes...you have to break a few eggs to bake a good cake.
Mistakes will be made....but I am gaining ground.
The drawing needs to be worked on a bit...but it's not much.
:pencil:

didyoung · Dec 20, 2016

Practice run on a design for more earrings.

SamW · Dec 21, 2016

Looking at your "straight" section Shawn, it looks to me that shaving off just a very few thousandths adding a slight curve to that section would provide the perfection you are looking for. If you try that, do about a thou at a time until satisfied. Looks great anyway!

didyoung · Dec 21, 2016

Thanks Sam
I recut my master and fixed the problem and even added a couple of cuts to improve the design....:banana:

Mike_Morgan · Dec 22, 2016

It looks great, Shawn!

didyoung · Dec 22, 2016

Thanks mike

didyoung · Dec 22, 2016

A new drawing I came up with....still stuck on those German leaves. :drawing:

Jerry K · Dec 22, 2016

From my prospective the German leaves seem to be a GREAT place to be stuck! Brilliant design.
Thanx for showing.
Jerry K.

Eugene Carkoski · Dec 23, 2016

it all great, is the back engraved as well?

AliAtiyabi · Dec 23, 2016

Very nice works.

Pendant and drawing

didyoung

~ Elite 1000 Member ~

Attachments

didyoung

~ Elite 1000 Member ~

Attachments

SamW

:::Pledge Member:::

didyoung

~ Elite 1000 Member ~

Mike_Morgan

Elite Cafe Member

didyoung

~ Elite 1000 Member ~

didyoung

~ Elite 1000 Member ~

Attachments

Jerry K

Elite Cafe Member

Eugene Carkoski

Elite Cafe Member

AliAtiyabi

Elite Cafe Member

Latest posts

Sponsors