MICHAEL
Elite Cafe Member
Did this shotgun at least 9 months ago before I understood beveling cuts to inside of design. It was very difficult to engrave so small, especially when I like to cut deep. My friend has really taken over the CCH. He did it this morning. Any helpful input on getting better colors In areas where grey showed up are welcome. Has anyone experience with a tough clear finish like Turnbull uses? We've been trying to use deft but not on a firearm yet. He going to experiment with clear bake on gun-kote next. Any advice on improving my engraving and design are always welcome. Plan to do a Belgian blue on the barrel when time permits.