Fxdb

New Member
Joined
Aug 15, 2016
Messages
4
Hi all

I'm just getting into engraving motorcycle parts and have been looking at engraving systems. I took a class and was able to use the grs and the lindsay. However there is quite a price difference between the two. Is there a benefit of one over the other? Do I need palm control? The two systems I am considering are the gravermax/ or Mach at or the lindsay classic. Your recommendations? Also would an air compressor that is 1 hp/ 5.5 gal be sufficient?
 

dlilazteca

~ Elite 1000 Member ~
Joined
May 10, 2013
Messages
2,659
Location
Laredo, Texas
You're really not going to get many answers to that question has been asked a thousand times read the stickies on systems both the systems you mentioned will get the job done.

Having used both, buy the one you liked best thats whats important, price averages about the same in the end, go with your gut on this one, but like I said both will work wonderfully in the right hands.

GunEngraver.com Guns, Knives & More
 
Last edited:

Eugene Carkoski

Elite Cafe Member
Joined
Jun 24, 2012
Messages
370
Location
Omaha, Ne.
I like the lindsay system my self, I have a gravermister and have used GRS. I also have dozens of hammers because only 1 won't due
 

Latest posts

Sponsors

Top