Hey guys, I've been lurking a while. I'm a knifemaker, getting into engraving. I found a good deal on a GraverMax, with two hand pieces, that just came in.
I'm wondering if you guys can identify the handpieces, and tell me if they take QC holders or not?
They've got a round receiver, and I can't see any visible set screw or anything.
Here's the only photo I've got atm, but if necessary, I can take some of the ends of the hand pieces.
Thanks for the help!
I'm wondering if you guys can identify the handpieces, and tell me if they take QC holders or not?
They've got a round receiver, and I can't see any visible set screw or anything.
Here's the only photo I've got atm, but if necessary, I can take some of the ends of the hand pieces.
Thanks for the help!