Bought a Gravermax, need help identifying handpieces.

jdempsey · May 25, 2016

Hey guys, I've been lurking a while. I'm a knifemaker, getting into engraving. I found a good deal on a GraverMax, with two hand pieces, that just came in.

I'm wondering if you guys can identify the handpieces, and tell me if they take QC holders or not?

They've got a round receiver, and I can't see any visible set screw or anything.

Here's the only photo I've got atm, but if necessary, I can take some of the ends of the hand pieces.

Thanks for the help!

tim halloran · May 25, 2016

jdempsey: They are both quick change handpieces.

jdempsey · May 25, 2016

Thank you Tim, am I correct in thinking that the longer one is likely a qc710 handpiece then?

tim halloran · May 25, 2016

jdempsey: I think your right, and the other one is an 800 series. I'm not absolutely sure about the smaller one. They are some of the first quick change handpieces.

jdempsey · May 25, 2016

Excellent, thanks again Tim. I guess regardless, I need to order QC collets, or whatever they're called.

Bought a Gravermax, need help identifying handpieces.

jdempsey

Member

tim halloran

Elite Cafe Member

jdempsey

Member

tim halloran

Elite Cafe Member

jdempsey

Member

Latest posts

Sponsors