vdrum4250
Elite Cafe Member
I am using and air engraver GRS GRAVERMACH with a 901 hand piece and QC holders with a dozen or so of traditional gravers.
I have decided that i need to start with 90, 120 or other round and square gravers.
I am almost sure that my QC holders have a 3.5mm hole, so i am assumingthat 3/32(2.35mm) and 1/8 ( 3mm) graver blanks in square or round will work to make 90 and 120 gravers with heals right?
I have coming a powerhone with diamonds.
and suggest or input to get correct blanks and source would be helpful
thanks
btw..im totally new so the traditional gravers are digging in..
I have decided that i need to start with 90, 120 or other round and square gravers.
I am almost sure that my QC holders have a 3.5mm hole, so i am assumingthat 3/32(2.35mm) and 1/8 ( 3mm) graver blanks in square or round will work to make 90 and 120 gravers with heals right?
I have coming a powerhone with diamonds.
and suggest or input to get correct blanks and source would be helpful
thanks
btw..im totally new so the traditional gravers are digging in..