cool video!

Josephnmora · May 19, 2016

Check this out...hand power & pneumatic and uses talk. It in Spanish, but video shows it all
https://youtu.be/-eSqnAZ_2nI

I getting lesson on more engraving....awsome skill...:biggrin:

rmgreen · May 19, 2016

Wow! Perhaps he did not read the same instruction books and what has said here that one must move the work piece into the graver while holding the graver relatively stationary. Or were my eyes/mind playing tricks on me! Speed of design and execution just mind blowing. Thanks for sharing.

Josephnmora · May 19, 2016

thank you, I did not understand most of the Spanish....found that there is lot of show and tell out there on basic for engraving which i searching for and finding just awsome work here on engraver cafe and the internet.

monk · May 19, 2016

probably the best ever to show the advantage of direct drawing on a part ! this should be viewed by all newbies. even a few of the old far-s that lurk here. jmho

Ragnarok · May 20, 2016

wow....I didn't understand much of what he said, but the work looked great and he was fast. Hand engraving while you wait.

bronc · May 20, 2016

That's impressive!

Stewart

cool video!

Josephnmora

Member

rmgreen

Elite Cafe Member

Josephnmora

Member

monk

Moderator

Ragnarok

Member

bronc

Elite Cafe Member

Latest posts

Sponsors