Bulino Tool

Ron Jr.

Elite Cafe Member
Joined
Dec 30, 2009
Messages
211
Location
Viroqua, WI
I often get asked what tool I use for my dot bulino so I thought I'd share a couple pics. It's certainly not traditional but it works well for me. The tool itself is pretty basic, a pen shaped stainless steel graver holder with an aluminum triangle tightened onto the shaft to help with leverage. The back end of the holder is between my index and middle fingers to lessen the angle I hold it at, it makes seeing/placing the point of the graver a lot easier for me. As for the graver itself its just a 90V with a 45 degree face. Sometimes I make the face steeper if the material is extra hard/tough.
 

Attachments

  • bulinograver1.jpg
    bulinograver1.jpg
    107.4 KB · Views: 387
  • bulinograver2.jpg
    bulinograver2.jpg
    66.2 KB · Views: 383
Top