grumpyphil
Elite Cafe Member
- Joined
- Sep 18, 2011
- Messages
- 106
Hi All-
I realize this subject has been covered at some length but I'm wondering if anyone has tried using a screwjack as a support and if so, how it worked out. I'm in the midst of rebuilding my engraving station after a move and for a variety of reasons the drillpress stand route won't work for me. I've been looking at a variety of heavy bottle jacks, screwjacks and trailer supports and wondering if these might not work as support.
Any info or opinions would be appreciated.
I realize this subject has been covered at some length but I'm wondering if anyone has tried using a screwjack as a support and if so, how it worked out. I'm in the midst of rebuilding my engraving station after a move and for a variety of reasons the drillpress stand route won't work for me. I've been looking at a variety of heavy bottle jacks, screwjacks and trailer supports and wondering if these might not work as support.
Any info or opinions would be appreciated.