Boomhower
Elite Cafe Member
I have been working on a design for a potter's wheel style kick wheel for hammer and chisle engraving and have run into a bit questions
When I get this built it wood be a good set up for a microscope I am thanking.
would there be any issues using a scope this way?
I am aways from getting a scope but I want to build this setup one time
My main question is what wood be the working distance using a microscope ?
I looked around and seen some from 8" to 14" but I am lost on how they are measured
Do they measure from the work pice to the bottom of the scope ?
Thank you very much for your help with this. :hammer:
When I get this built it wood be a good set up for a microscope I am thanking.
would there be any issues using a scope this way?
I am aways from getting a scope but I want to build this setup one time
My main question is what wood be the working distance using a microscope ?
I looked around and seen some from 8" to 14" but I am lost on how they are measured
Do they measure from the work pice to the bottom of the scope ?
Thank you very much for your help with this. :hammer: