Latergaters
Elite Cafe Member
I'm having a hard time finding a decently priced used drill press to use as a stand for my vise. The vibration is driving me batty.
While discussing this with my husband I joked that I was getting ready to buy a couple bags of concrete, a long shallow Rubbermaid tub, some steel pipe, and plastic sheeting to make one that can't vibrate.
Lay the plastic on the floor, tape the tub upside down on it, cut a hole for the pipe, fill with concrete, put the pipe in, fill with more concrete and plumb, set some sort of table top on into the concrete.
I'm in an unfinished basement so it's doable but not sure it'd be the best option.
Sent from my SAMSUNG-SM-N910A using Tapatalk
While discussing this with my husband I joked that I was getting ready to buy a couple bags of concrete, a long shallow Rubbermaid tub, some steel pipe, and plastic sheeting to make one that can't vibrate.
Lay the plastic on the floor, tape the tub upside down on it, cut a hole for the pipe, fill with concrete, put the pipe in, fill with more concrete and plumb, set some sort of table top on into the concrete.
I'm in an unfinished basement so it's doable but not sure it'd be the best option.
Sent from my SAMSUNG-SM-N910A using Tapatalk