lower budget shotgun

Beathard · May 10, 2015

Every once I awhile I get a low cost sentimental gun for some engraving. This one had a very small budget. So I attempted to put some animals on it without taking a lot of time. The thought was to put the minimal engraving time in but still have the animals say what they were without the need for explanation.

dlilazteca · May 10, 2015

Mission accomplished

Saludos,
Carlos

mtlctr · May 11, 2015

looks good, how did it cut? I have an old Champion brand single shot I could "pratice" on.:hammer:

Beathard · May 11, 2015

Cut like butter

DKanger · May 11, 2015

I have an old Champion brand single shot

I thought that looked like a Champion, but mine only has three holes in it, instead of four and the serial # is on the bottom tang..

dogcatcher · May 11, 2015

That squirrel looks awesome.

monk · May 11, 2015

i think it's great to do such as you have. personal pride in ownership need not be reserved for the affluent only. every time i see a squirrel, i think of james b. meeks. his squirrel alone will survive for all time.

mtlctr · May 11, 2015

Beathard said:
Cut like butter

The one I have the reciever looks case hardened. does it have to be annealed?:hammer:

Beathard · May 11, 2015

This one was painted. Used white gas to get it off. Many of these old guns are case colored not hardened. Rust remover will usually take it off.

lower budget shotgun

Beathard

~ Elite 1000 Member ~

dlilazteca

~ Elite 1000 Member ~

mtlctr

Elite Cafe Member

Beathard

~ Elite 1000 Member ~

DKanger

~ Elite 1000 Member ~

dogcatcher

Elite Cafe Member

monk

Moderator

mtlctr

Elite Cafe Member

Beathard

~ Elite 1000 Member ~

Latest posts

Sponsors