blacksmith_wills
Member
- Joined
- Jul 27, 2011
- Messages
- 76
GRS sells a little QC Adapter for their Dual-Angle Shapener, "QC Tool Adapter V2" Item #003-320-V2.
You can modify the adapter to work with the Enset collets by drilling a hole on the centerline of the adapter 10mm back from the flat end of the adapter. The little nub for the GRS collets will be at the opposite end.
Put the adapter in normally for GRS collets, swap the adapter end for end to hold the Enset Collets.
Oh, yeah, ignore the little divot in front of the hole, operator error.
Hope this helps!
Matt
You can modify the adapter to work with the Enset collets by drilling a hole on the centerline of the adapter 10mm back from the flat end of the adapter. The little nub for the GRS collets will be at the opposite end.
Put the adapter in normally for GRS collets, swap the adapter end for end to hold the Enset Collets.
Oh, yeah, ignore the little divot in front of the hole, operator error.
Hope this helps!
Matt