+ Reply to Thread
Results 1 to 1 of 1
  1. #1
    Join Date
    Nov 2006
    Post Thanks / Like

    Default Peg vice

    Hi Tomy,
    This is how we get them form a jeweller's supply.

    This is what they look like separated form the handle.

    In my shop, the handle is modified to fit a bench mate system for setting diamonds.

    You can put the head in your chuck the same way I do in the ball vice.
    I use this method to hold small stuff for setting or engraving.

    I hope this helps you and everyone else on the forum.


    ps, you can use 1/8 brazing rod for the pegs.
    Last edited by jimzim75; 10-06-2007 at 10:22 PM.
    I never get tired of talking, joking, arguing, discussing, a subject that holds our attention most of the day. Engraving.

    Jim Zimmermn
    Hand Engraving Canada ~-~-~-www.handengravingcanada.com

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

H&C banner

GRS Skyscraper

Jumbo Pin Plates

Drawing Scrolls

Cafe page views since 18-Nov-2006.