So im pretty new and I have been struggling to progress with hand tools. While I like hammer and chisel , i want to move on to a powered setup.
I dont have alot of money so im limited to the magnagraver which i like because of its flexability to do single hits like a chisel.
But here is where im worried. I am worried about how much the flex shaft gets in the way of working.
I have a ball vice so I am assuming this will extend the flexability of the tool 10 fold , where as without a ball vice im sure working with it would be extremely hard compared to a tiny vinyl hose from a air powered handpiece.
I tried looking online for videos to see the tool in action , but I could not find any.
Would a magnagraver be a good first power tool?
I dont have alot of money so im limited to the magnagraver which i like because of its flexability to do single hits like a chisel.
But here is where im worried. I am worried about how much the flex shaft gets in the way of working.
I have a ball vice so I am assuming this will extend the flexability of the tool 10 fold , where as without a ball vice im sure working with it would be extremely hard compared to a tiny vinyl hose from a air powered handpiece.
I tried looking online for videos to see the tool in action , but I could not find any.
Would a magnagraver be a good first power tool?