I have a Sil Air 20A compressor that I attempted to run for the first time last night. After filling it with oil I plugged it in, it ran for about 5 seconds and then quit. I have not been able to get it to run since. I have checked the power supply and I have power. Reading the manual I do not see much else that I can check. The manual asked if the holding tank is fully pressurized, no because it only ran for 5 seconds. Thermal overload tripped? Since it only ran for 5 seconds I doubt that is the case, plus that resets itself after 15 minutes.
So anybody got any suggestions? :thinking:
So anybody got any suggestions? :thinking: