After reading the poll about who is engraving what, and noticing that there is a large percentage of western engravers out there, I thought I would pose a question. When soldering soft overlays on silver, ie. copper , jewelers bronze, etc. which method works best for you?, and which solder do you use? I am interested because I just returned from a large show in Las Vegas and a large percentage of the overlays were soldered, some of them very fine and thin. I was wondering if they were pre-tinned , or just how it was done. I know the more experienced engravers have some tried and true methods , and was hoping that they would share. Thanks for hosting this fine forum.