Talking about concave / convex surfaces.

TyG · Feb 20, 2014

This is an end cap for a bagpipe set, the top surface of the cap has a curved recess that the cutomer wanted engraved, bright cutting on that was a nightmare. The flat was so much easier.

TyG · Feb 20, 2014

And yes, I know I need a good camera.

LVVP · Feb 21, 2014

Any ware, it is a very good work

RDP · Feb 21, 2014

Great work there mate! I think you have a good camera, but in this art you also have to be a photographer,

hahaha.

Richard

Willem Parel · Feb 21, 2014

You can have my camera if I can have your skills!!!

scott99 · Feb 21, 2014

HI, to me everything is a nightmare until I do it a few times and figure it out. It looks like you have figured this one out very well. Nice cutting.

scott99

ETHELBERT · Feb 24, 2014

This looks as though it was quite challenging, especially showing the concave as you did....great job!

monk · Feb 25, 2014

ummm-quite tasty to my eye.

Talking about concave / convex surfaces.

TyG

Elite Cafe Member

Attachments

TyG

Elite Cafe Member

LVVP

~ Elite 1000 Member ~

RDP

Elite Cafe Member

Willem Parel

~ Elite 1000 Member ~

scott99

Elite Cafe Member

ETHELBERT

Elite Cafe Member

monk

Moderator

Latest posts

Sponsors